Wiha 47210 Wallbox measuring adapter type 2 for installation tester

Product dimensions: 260x100x80 mm (LxWxD)

Application: For functional and safety testing of charging stations (wall mounted charging equipment) in the area of electromobility.

Quick and easy functional test of wallboxes with type 2 connection

Intuitive operation using a slide switch for CP mode selection

Enables simulation of the error “E” for a comprehensive diagnosis of the wallboxes in accordance with VDE specifications

Use of the measuring adapter without an installation tester thanks to integrated LED status displays

The safe functioning of wallboxes is essential, whether during initial connection to the power supply or during recurring tests, in order to avoid follow-up costs and safety risks. The Wiha wallbox measuring adapter, together with the installation tester, supports the fast, safe, and standardized testing of wallboxes directly via the station's type 2 connection, so there is no need for time-consuming reconnections. The slide switch can be used to simulate the actual vehicle conditions of the control pilot: from A – “Vehicle not connected” to B –“Vehicle connected, not ready for charging” to C – “Electric vehicle connected, ready for charging, ventilation not required”. In addition, the CP error “E” is simulated so that a comprehensive diagnosis of the wallbox can be carried out in accordance with VDE specifications. The integrated LED display provides clear feedback at all times on whether the device is ready for charging and the charging phase, even without an installation tester for a quick check. In combination with the Wiha installation tester, typical measurements can be carried out, such as voltage, frequency, phase sequence, various RCD tests (also for EV RCDs with 6mA DC fault currents), insulation resistance, low-resistance measurements, line and loop impedance.The slide switch can be used to simulate the actual vehicle conditions of the control pilot: from A – “Vehicle not connected” to B –“Vehicle connected, not ready for charging” to C – “Electric vehicle connected, ready for charging, ventilation not required”. In addition, the CP error “E” is simulated so that a comprehensive diagnosis of the wall mounted charging equipment can be carried out in accordance with VDE specifications. The integrated LED display provides clear feedback at all times on whether the device is ready for charging and the charging phase, even without an installation tester for a quick check. In combination with the Wiha installation tester, typical measurements can be carried out, such as voltage, frequency, phase sequence, various RCD tests (also for EV RCDs with 6mA DC fault currents), insulation resistance, low-resistance measurements, line and loop impedance.

Use with the Wiha installation tester.

Safety and functional testing in accordance with DIN VDE 0100-600 (IEC 60364-6) and DIN VDE 0105-100 (EN 50110) for wall mounted charging equipment in accordance with DIN VDE 0122-1 (IEC 61851-1).