Schneider Electric BSH1401P11A2A Servo motor BSH - IEC 140 mm - 11,1 Nm - 1500 rpm -eje c chaveta -sin freno -doble conector acodado orientable -encoder abs ST 128b SinCos -IP54

BSH series servo motor for the Lexium 32 series of servo drives. This BSH series of three-phase AC servo motors has a low rotor inertia, allowing for high acceleration capabilities for dynamic applications. Thanks to the winding technology, there is a higher power density in a compact design. This servo has a nominal continuous stall torque of 11.1 Nm and reaches a peak torque of 27 Nm. Its rated speed is up to 3600 rpm depending on the supply voltage. There is a voltage-dependent rated power of up to 3170 W. The built-in encoder is designed as a single turn with 128 periods/revolution (128x1024) as SinCos Hiperface. The electrical connection is made via 2x M23 connectors, angled and rotatable by 90 degrees. The motor flange for mounting is 140 mm. The drive shaft has a diameter of 24 mm. The shaft end is designed with a keyway and conforms to protection class IP54. The motor housing corresponds to protection class IP65. There is no holding brake present. For the operation of the synchronous motor, the servo amplifiers of the Lexium series LXM32 are recommended. Thanks to the Green Premium environmental label, you can receive detailed information about material content, environmental impacts, and the circular economy to support your sustainability goals.